Auto Ingress Device Manager Digital Mode Pad

Over View

These models use microcontroller based intelligence utilizing purpose designed remote key pad for all error
and warning messages, controls, functions and adjustments.

To reboot/reset the microcontroller three options are available:

1. Switch mains power off for 30 seconds and switch back on while the door is on Auto mode. If
   the door is in Lock mode then press the exit push button switch, after power up or change mode
   to auto.
2. Press the reset button on the underside of the key pad. This is a recessed button accessible
   through a hole on the underside of the key pad enclosure.
3. Press the up key on the key pad and hold down for 10 seconds.
   The door may require resetting if there is disruption to mains power or power surges or certain
   abnormalities and malfunctions. This is generally recognised when the door is operating slowly or erratically
   or the key pad display shows safe or unknown modes.
   User Accessible Key Pad Options

Mode Change

The user may use the key pad to change the operational modes. This is done by pressing the mode
button on the key pad followed by the user code (default code 1234) if requested. All subsequent
press of the mode button will show the 5 different mode options; Auto, Exit, Lock, Open and
Manual. Select the desired mode by pressing the enter button.
Auto Mode – Door will open then close for normal operation from both the inside and outside sensors. The
door will not lock when closed. When manually pushed open approximately 100mm the door will open by
itself. The doors will failsafe to the open position on power failure unless the failsafe is set to open close.
The door in this case will operate normally until the battery is flat or the mains power is restored.

Exit Mode – Door will open and close from the inside or exit sensor only. The door will lock after every
operation when shut. It will unlock and open on power failure unless set to open/close as in Auto mode
above.
Lock Mode – Door will not operate from either sensor. It can be opened from the after-hours exit push
button switch or entry switch. The door will remain locked on power failure. The after-hours push button
switch will unlock and open the door with or without the mains power present. The door will close and lock
after every operation.
Open Mode – The door will remain in the open position.
Manual Mode- allows the door to be opened and closed by hand and left in any position. The door will
recalibrate when any other mode is selected before resuming normal operation.

Note: mode changes may also be made using the key mode or knob switches or by the building
management or security/access control systems if connected, or the built in time clocks if enabled via the
key pad or add on time clocks if fitted.

When multiple devices are connected for mode control the order of precedence for the mode setting is:
Open, Lock, Exit and Auto. Auto is the default mode.
Page